Farmall & IHC Tractors Discussion Board |
806 injection pump timing.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave Thuesen on December 11, 2002 at 14:03:27 from (192.43.65.245):
Im working on a 806 injection pump. It is IH oun pump. I have the pump removed and I set the pointer on the front pulley to the first mark in running direction. Im see no sloted holes in the pump housing for timing adjustments. What should the timing be set at, and where shuold the marks line up for the front pulley and degrees on the flywheel. Im a John Deere mechanic, Ive called three different Case IH dealers and none have mechanics that have been aruond long enough to give me the correct infomation. There is a pointer inside the pump side cover with degree numbers. I also need to remove the drive hub because the inj pump place gave me a rebuilt pump and they need the old hub. Does anyone have the correct timing and installation proceedure for this IH pump? AS ALWAYS, Thank You!! Dave Thuesen
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|