|
Farmall & IHC Tractors Discussion Board |
WD9 Camshaft specs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by chuck on December 25, 2002 at 20:16:06 from (161.184.19.161):
I have removed the cam from my WD9 and the lobes don't look too bad.The lobe heights vary from 1.771 to 1.777 inches.The lobes vary in sharpness and I am wondering if the intake and exhaust valve lobes have a different configuration?
Starting from the front the lobes are rounded-sharp-sharp-rounded-rounded-sharp-sharp-rounded.Is this not the pattern that the valves sit in the head,in other words ,do the exh and int vales have different lobe configurations i.e.different degrees of opening?
Would anyone have the camshaft specs for a WD9?
Any comments appreciated
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
