Re: magneto point gap

Posted by gene b on December 27, 2002 at 04:44:43 from (63.15.134.247):

In Reply to: magneto point gap posted by craig on December 26, 2002 at 14:15:24:

By adding an external coil you didnot make it a dist it is still a mag so set the points at the mag setting you better check that the rotor lines up with the terminals on the cap and that you have it in the proper registration #1 firing pos for the rotor is at about 2oclock. The cap has the #1 pos marked. Make sure that #1 piston is on firing tdc look in the cycl and you can see the piston will be up and mark on flywheel is at the bottom, You can be 180 out if not done correctly. Turn over with finger in hole and there will be pressure as piston is raised.

Follow Ups:

• Re: Re: magneto point gap Diesel Don 06:34:49 12/27/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: magneto point gap Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]