|
Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall H bull pinion shaft oil seals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick on January 05, 2003 at 15:12:56 from (172.166.89.211):
In Reply to: Re: Farmall H bull pinion shaft oil seals posted by Ron on January 05, 2003 at 14:30:19:
I ordered my seals from Carter & Gruenewald, a Case dealer in Wisconsin (866-327-6255). Ask for Ken. He has been a real help to me in finding parts I need (much better than my useless local Case dealer). I haven't received the order yet, so I don't know for sure whether I am getting the right parts. The parts book shows 3 different part numbers (48498 D, 358777 R91, and 360252 R91). Ken told me that these part numbers will all interchange. All are single-lip seals, not the double lip original seal. I am going to try to install two single-lip seals per side and hope that will work.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
