|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Wide Front End Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on January 07, 2003 at 12:49:01 from (63.110.182.225):
In Reply to: Re: Re: Re: Wide Front End Question posted by Dick Davis on January 07, 2003 at 05:04:58:
The H front steering bolster and the vertical shaft is a smaller demension in the bolt pattern and size of parts, example is tricycle front for H is smaller than M, however the first WFA from IH with leading tie rods was different than the later one with trailing tie rods, this is the one that evolved onto the 560 and up. I know the wheel bearings sets are to fit only H/350, the next set fit M/450, they are bigger of course.
Follow Ups:
Home
| Forums
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
