|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 6v generator to 12v generator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Heath on January 24, 2003 at 10:27:38 from (208.29.50.216):
In Reply to: Re: Re: 6v generator to 12v generator posted by JohnG(TX) on January 23, 2003 at 18:36:08:
The coil spring needs to be shortened on the coil which is connected to the F (field) terminal. It has lighter windings than the cutout coil which disconnects the battery when you shut the tractor off. If you have a 3 brush generator I am not positive it will work but I can check Monday if you want. This advice comes from Ed Dombrock, former IH service manager from the St. Paul, MN branch and he currently is instructor at WITC New Richmond. He has done this many times and it works well. Let me know if you need me to ask for more advice.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
