Farmall & IHC Tractors Discussion Board |
Re: 350 utility- value
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AG in IN on February 04, 2003 at 19:03:32 from (205.188.192.189):
In Reply to: 350 utility- value posted by Kirk on February 04, 2003 at 16:33:12:
If the TA and clutch are good, it runs good, sheet metal is straight, lights work, chrome's all there, tires are 75%+ and not checked, your hydraulics are good, front end is tight, and loader & Hoe work properly, it would bring roughly $3200-$3800 in NCIN. Just a ballpark number. Nice paint adds about $800-1000, Nice fenders add about 250-300, Diesel or LP engine can add or subtract depending on buyer. If the metal is rough, - up to $500. If any chrome is broken or missing, -$25 per piece, good seat and steering wheel are +'s, as is working tachometer, gas cap w/ guage, weights, the list goes on and on. Little things add up each way. Good luck with it. Just my 2 cents, which seems to be all that's in my wallet these days, Andrew Ginter
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|