|
Farmall & IHC Tractors Discussion Board |
Re: farmall M 5th gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mr. J on February 18, 2003 at 07:50:42 from (204.184.253.248):
In Reply to: farmall M 5th gear posted by joe on February 17, 2003 at 19:21:50:
Joe, What it probably means is that your truck came with steel wheels from the factory. The bolt that you need to remove is located underneath the rear gas tank support in front of the shift lever. I don't have a picture of the bolt, but more than likely it will be very corroded and rusty, I had to remove mine by taking a cold chisel and turning the bolt with a chisel. Be sure and not let any of the rust fall into the hole where you remove the bolt. You will need a 1" long replacement bolt....maybe 1 and 1/2". Once you remove the bolt, you will have a New Old Stock 5th gear in your tractor. Good luck, I have done this before so, if you need further instruction, I'll try to help... Jared Jeffries
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
