Farmall & IHC Tractors Discussion Board |
Re: F-20 piston sleeve clearance
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dlp on February 20, 2003 at 17:42:31 from (130.184.114.158):
In Reply to: F-20 piston sleeve clearance posted by Shawn in MN on February 19, 2003 at 18:19:32:
My book shows .004-.005" is what it is supposed to be honed when new. I don't know what the reject size is. My engine has .020" clearance between piston & cylinder wall. I'm going to have the pistons knurled, not the best way to go, but I'm just using it for show & pull. I believe it will be fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|