Farmall & IHC Tractors Discussion Board |
Re: Re: Play day on Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Shuler on February 25, 2003 at 22:11:10 from (152.163.189.203):
In Reply to: Re: Play day on Super C posted by SAm in NS on February 25, 2003 at 10:40:29:
I have one set of wheel weights and my 220 lb rear end on it. I have a two point rear blade on it that I would guess weights at least 250-300 lbs. One set of front wheel weights and the weight of the front blade. Some of the drives I graded were very steep. I found backing up them and pushing down worked well. The only place I did much spinning was at an intersection that had seen heavy morning traffic and the cars had it polished. It was on a slight grade and I did spin all the way up that hill. On the slick spot it seemed like a high gear with very low rpms, I mean all most a stall seemed to get me up the hill in pretty good shape.A Toyota 4 runner and a Suburban both fish tailed in the same spot in 4 wheel drive. Chains would have been nice on the ice but have not needed them pushing the snow at all.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|