Farmall & IHC Tractors Discussion Board |
Re: 806 Wheatland
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on February 26, 2003 at 19:08:07 from (205.188.209.78):
In Reply to: 806 Wheatland posted by Brandon on February 26, 2003 at 18:14:08:
During the earlier letter series tractors there was more noticable difference in the wheel type (McCormick or International) and row crop tractors (Farmall)than the later tractors starting with the 706, 806, 1206 series. However there were still considerable differences. We called what you call a wheatland tractor a wheel tractor. In lots of areas they were called a standard tractor. At that time, all Farmalls were row crop tractors. These comments are referred to the 706, 806, & 1206 mainly. The Farmalls were available with single front, dual tricycle front, or wide front axle. The International versions of these were only available with a wide front axle which had a complete different steering setup and front bolster setup and was also a shorter wheelbase. The whole front axle was completely different. The rear wheels were different although they did now clamp and slide on the rear axles whereas prior to this series all wheel tractors had non sliding rear wheels. The rear operators platform was completely different as were the fenders. A hand clutch was optional on the Internationals but not Farmalls. The International 706, 806, 1206 had the headlights mounted in the grille whereas the Farmall versions had them located on the side of the hood at the gastank location unless they were fitted with flat top fenders in which case they were mounted in the fenders. Three point hitch was available on both the Farmalls and Internationals. If the International you have found does not have a three point it would be difficult to add the three point but it could be done. You would have to incorporate all of the lower linkage torsal bar sensing as well as all of the upper rocker arm equipment just for a start. It would be a major project. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|