Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: IH460 issue with going to more than half trottle quickly.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chuck on March 14, 2003 at 11:55:45 from (216.170.58.10):
In Reply to: Re: Re: Re: IH460 issue with going to more than half trottle quickly. posted by Dave Gibson on March 13, 2003 at 21:28:14:
This flapper valve as you call it directs hot exhaust down to the bottom side of the intake manifold when the engine is cold to help atomize the fuel and give better cold weather operations.It then closes off that chamber when the engine warms up so the engine will alow more cold air into the cylinders and develop more horsepower.This chamber is usually filled up with carbon so that hot exhaust gas can't circulate like they were intended to.To clean out this chamber you will have to remove the manifold and remove the four bolts holding the intake and exhaust manifolds together and take a hammer and pick and knock all the carbon loose,but be aware that all four of those bolts will probablly twist off.Replace the bi-metal spring when you put it back together.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|