Farmall & IHC Tractors Discussion Board |
Farmall H Overbore Sleeves 3/3/8 to 3/7/16?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew from Australia on March 19, 2003 at 21:22:27 from (203.108.4.132):
Hello, I am doing up a Farmall H standard. Am I right in thinking that the "overbore" sleeves 3 7/16" will fit straight in a standard H engine with out modification to the block? This would upgrade it from an H to a Super H? I know this is a question that probably comes up all the time and I'm sorry to repeat. I couldn't see anything in my quick look in the archives. Thank you for your response. PS The engine is a kero job (assume low comp head)and I was going to go for some flat top pistons to suit. Sound OK to you guys? I paid A$100 (US$60) for it seized and it's cleaned up pretty well so far. Should be a fun machine to use. Regards Andrew Sydney, Australia
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|