Re: H-gear grinding

Posted by Tim K. on March 22, 2003 at 02:19:04 from (216.175.23.46):

In Reply to: H-gear grinding posted by Red Man on March 19, 2003 at 13:17:41:

Depending how long it has been sitting it might have a dry pilot bearing and could use a shot of grease thru the flywheel access hole but don't give it to much because it will come out and get in the clutch disc. The zerk is viewable after putting the tractor on top dead center No.1 and then looking from the bottom, one or two shots should do it and should be done anyway , some have probably never been done.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: H-gear grinding Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]