|
Farmall & IHC Tractors Discussion Board |
Re: trouble finding oil seals for H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MN Charlie on March 24, 2003 at 14:09:14 from (156.99.90.178):
In Reply to: trouble finding oil seals for H posted by jmyt_47 on March 24, 2003 at 11:19:02:
Your parts man did not do too good of a job of looking for the governor shaft seal. The old number 45667D changes to 66440C1 and that number has been used for many years. It's still available for about $6.00 I just got 4 of them two weeks ago. All of the parts that I have order for governor repairs are available but some are $$$$$. As for the seal on the dist drive shaft. Are you asking about the seal for the drive shaft that is in that short housing, about 5 inches long that drives the dist or mag. The parts book shows a 352080R91 optional with 358839R91 but this seal is only used on serial number 268224 and up tractors. I don't know what is used on low number tractors. I have my 39 H all apart and I'll check to see what's in that housing. I need to take it apart before I sandblast it anyways. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
