|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 300U Power Steering Problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on March 27, 2003 at 12:15:46 from (130.76.32.20):
In Reply to: Re: Re: 300U Power Steering Problem posted by Bill on March 27, 2003 at 10:22:46:
You're talking about the fitting that feeds pressure from the back bank of valves to the front bank? If so, you could probably make a cover plate from 1/2 inch or so steel, and put a hole in line with the pressure passage, tap that hole for a hydraulic hose fitting and feed your front valves with that. If you don't have front valves (i.e. you only have fast-hitch, no loader or remotes) you don't need that fitting, so the cover you have should work fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
