|
Farmall & IHC Tractors Discussion Board |
Re: Farmall H light switch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bigdog on March 30, 2003 at 06:57:59 from (157.254.98.201):
In Reply to: Farmall H light switch posted by Nick on March 30, 2003 at 06:51:10:
The 4-position switch was used on systems with a cut-out rather than a voltage regulator. The designations are: L - low charge, H - high charge, D - dim lights, B - bright (less dim) lights. In the low charge position, the generator output was reduced by placing a resistor in the feild circuit ground to prevent over-charging of the battery. In the high charge position, the feild grounds directly and output is increased. (Great for short running periods with lots of engine re-starts.) Voltage regulators on later models made this un-necessary.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
