Farmall & IHC Tractors Discussion Board |
Overdrive Problems Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan Rosien on April 02, 2003 at 13:37:58 from (207.250.224.4):
1951 Farmall M with a transmission overdrive feature. I think it is an M&W add-in. Looking for parts diagram and/or repair suggestions. Transmission is stuck in high range. Cable mechanism is free and operates well. I have the transmission case open and can observe gears. However, I cannot tell if parts are missing or broken since I have no diagram to tell me what should be there. Overdrive gear seems to be stuck in place which is the high range. Should there be bushings, pins, springs or other parts in place that would allow overdrive gear to move? Anyone with experience or insight to the problem is welcome to offer suggestions. Or if you have a parts diagram or repair manual information that would be helpful as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|