Farmall & IHC Tractors Discussion Board |
Re: Why cant I find just one ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on April 12, 2003 at 12:47:24 from (209.226.106.92):
In Reply to: Why cant I find just one ? posted by ThatOtherGuy on April 10, 2003 at 18:14:21:
You have a very good point, many times over the years I have seen these old gas Farmalls have one cylinder wear much faster than rest. I had that in my 130 a few years back. One cylinder was down to about 40 lbs compression while others remained over a 100 lbs. I my opinion no one is going to rebuild cylinders that are over 100 lbs., however I don't believe those should have a new piston, sleeve and rings put along side them. Every time we do a rebuild we should save the best 2 piston and sleeve sets. Might be great for us to have a registry of who has what. I tell you guys, the time has come for doing this type of thing. I went to CaseIH dealer other day, just for my anual supply of oil filters, points, etc. If I hadn't used my bank card, it would have taken a larger container to carry money in than parts out. The B@#$%%^&% anual inflation rate on new antique tractor parts must be somewhere in the 50% range. Talk about organized crime, and I thought all along it was bankers and politicians.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|