|
Farmall Tractors Discussion Board |
Re: CAN'T MOW WITH A SUPER C
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by JK MN on September 13, 1999 at 06:30:41 from (207.242.199.131):
In Reply to: CAN'T MOW WITH A SUPER C posted by BEGINNER BOB on September 12, 1999 at 20:50:09:
Bob, Be sure the leading, or front of the rotary cutter is lower then the back. With the front lower, (two or three inches) the blades only have to cut on the front half of the cycle, and are well above the stubble on the rear half, ie are not cutting the stubble lower. The cutter will require approx half the HP with the front lower then the back, as the blade can practically swing free on the back half of the cycle. This practice is especially helpful with lower HP tractors.
Follow Ups:
Post a Followup
|
