Re: converting two point to three point

Posted by F20II on April 21, 2003 at 11:09:48 from (208.187.14.169):

In Reply to: converting two point to three point posted by swampman on April 21, 2003 at 08:12:20:

There is a number of ways, (1) buy the three point setup from a vender ( very pricy) (2) IH made three point conversions which still can be found if you look hard enought, they used a link connector on the top to attach a three point peace of equipmnet ( were made out of cast iron ) or I have seen some home made ones useding the quick disconnect arms an welding two pieces together to make the triangle with a link coupler on the top. I have an IH coupler on my 340D which is pictured here, if you want to see side veiws go to my web page an look under the 340 section. Hope this helps you.

• Chucks Farmall Page

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: converting two point to three point Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]