|
Farmall & IHC Tractors Discussion Board |
Re: Re: Renting a vehicle for Hauling an 826?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim Malin on May 02, 2003 at 21:02:56 from (207.190.93.143):
In Reply to: Re: Renting a vehicle for Hauling an 826? posted by Bob G on May 01, 2003 at 15:55:08:
Hey Bob. Was that the biggest truck you could get? The axle width of an 826 is 92 inches, so it would be an exact fit, however, most likely about a half inch less than the tractor. It would probably work nice, as long as I can squeeze the tractor in width-wise. 83 inches tall, I believe with the muffler, but I could be wrong. Shouldn't have a problem in a Ryder truck for length and height, just width. I would expect the truck would be able to hold 8,000 pounds of cargo. Thanks for the post.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
