Farmall & IHC Tractors Discussion Board |
Thank you Hugh MacKay
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on May 03, 2003 at 19:29:04 from (68.13.130.145):
Just want to say thanks to Hugh as one of the few that have faith in the old 6 volt systems. My brothers wanted me to convert it to 12 volt but I held out. Put new battery cables on it and took a small disk grinder to make sure the ground was good. Spins it over like a top. The heaviest cables I could find on short notice was 2 gauge. So far I am happy with that. I paid a visit to my local CaseIH dealer and got a lot of seals, gaskets, etc for my two C's. They may be a little bit more expensive at CaseIH but you know that they are going to fit and work. It was kind of fun getting dirty and greasy for a change. Work in an office so don't get too dirty. Like they say: "You can take the boy out of the farm but you can't take the farm out of the boy". Looking forward to a summer of tractor shows and parades.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|