Farmall & IHC Tractors Discussion Board |
starter problems with 300 utility
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jay on May 05, 2003 at 14:58:41 from (209.143.48.55):
My 1955 300 ran fine the other day, then quit starting. The battery is fully charged and I had the solenoid and starter tested. The starter tested bad, so I got a reman 12 volt starter and installed it. My problem is that now it won't turn over. I think I might have connected the cables and wires wrong, but can't remember how they were originally. Can somebody tell me if I am right in the following: 1. positive cable from battery goes to the large solenoid post 2. red wire from alternator attaches to the same large solenoid post as battery cable 3. small (orange) wire from alternator goes on the small solenoid post 4. solenoid attaches to the large post on the starter. Does this sound right, or have I got something crossed? Any help would be appreciated. Anything else I should check out? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|