Farmall & IHC Tractors Discussion Board |
Re: Regular--F-20 questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on May 09, 2003 at 03:04:01 from (216.42.122.158):
In Reply to: Regular--F-20 questions posted by geo in MI on May 08, 2003 at 07:20:30:
There were 2 rear housings used,one was narrower[narrow tread],I saw in an article in Red Power magazine that IH used up its stock of housings on the very early F-20s when the Regular went out of production. A wide, or regular tread tractor with the 24" or 28" round spoke wheels will be close to 8 ft. wide. The use of 36" round spoke or the cast center wheels, turned in over the brake covers will make them some what less.I'm not sure about everything that is the same on both tractors.Have to say not a lot.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|