Farmall & IHC Tractors Discussion Board |
Re: IH Diesel Help needed!! Injector pump
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin (FL) on May 20, 2003 at 13:27:58 from (12.94.112.218):
In Reply to: IH Diesel Help needed!! Injector pump posted by Oldfarmboy Jim on May 19, 2003 at 23:18:32:
In regard to the advice on pressurizing the fuel tank, be very, very careful about that practice. Any pressures over about 2 PSI could result in rupture of the fuel tank. Some folks who read that may attempt to connect 125 PSI shop air to a fuel tank. The result could be a deadly spray of fuel and shrapnel, possibly fire. Another bit of advice on cranking a stubborn diesel--temporarily set up two batteries for 24V cranking. Cranking speed will just about double. Spray some motor oil (about a cup) into the intake. Or use liberal amounts of spray lubricant. Look for white smoke while cranking. As a last resort, you can use very small amounts of ether. If that doesn't work then you got a bad pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|