Re: H carb setting

Posted by CNKS on May 20, 2003 at 17:34:45 from (207.178.96.212):

In Reply to: H carb setting posted by Don on May 20, 2003 at 17:16:58:

Tractor should be warm. Set throttle wide open. turn main jet screw (bottom of carb) in until it runs rough, then out until smooth, perhaps an additional 1/2 turn. Close the throttle and turn idle screw (front of carb) until engine idles smoothly). Turning the idle screw in richens the mixture, the opposite of the main jet. The other screw is the throttle stop screw, which sets the rpm. Adjust it to the lowest rpm that gives a smooth idle. Advance throttle rapidly, and repeat adjustments of necessary. If either the main jet or idle mixture screw do not respond to adjustments, your carb needs cleaning, possible a kit, including needle and seat. Your float may need adjusting also. Timing needs to be correct, that's another story.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: H carb setting Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]