Farmall & IHC Tractors Discussion Board |
Re: Do I restore this M or part it out?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by red reaper on May 27, 2003 at 05:29:31 from (208.218.32.188):
In Reply to: Do I restore this M or part it out? posted by Bob in SE Nebraska on May 26, 2003 at 20:02:20:
I think I would junk it,unless you know how the rearend is and trans,unless it has sentimental value and the sheet metal is good.I also looked back at the H photos of the block cracked.I think if you just sleeved over that crack you could of saved it.Use a polymere while sliding the sleeve in.I did that on a 1206 cracked just as bad,and have pulled 20' emplements in the fields and it hasnt leaked yet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|