Farmall & IHC Tractors Discussion Board |
504 three point hitch parts.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J.R. on June 02, 2003 at 19:18:18 from (206.40.120.191):
I would like to sell a set of three point hitch parts for what I believe to be a 504. I have the two lower arms and the two vertical adjustable arms. The problem I have is, I am not sure if they are for a Row Crop or a utility tractor. The casting number on the adjustable vertical arms are 376528-R2 if this helps at all. Also what are they worth? I was told that they are new old stock from a dealer. Not sure. They do show a small amount of rust pitting, from sitting in a damp storage place, but there is no play in the balls, and no wear on the pins. I did wire brush them down and repainted just to freshen them up. Perhaps some one could measure the distance between the center of the holes on their lower arms on their 504 and let me know. Then I could match them up. If anyone could help me with this matter, it would be greatly appreciated. Thanks to all reply’s.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|