Farmall & IHC Tractors Discussion Board |
Re: Super C Questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on June 03, 2003 at 17:46:12 from (66.230.21.180):
In Reply to: Super C Questions posted by Anthony P on June 03, 2003 at 14:01:48:
Don't buy anything except oil and filters for it at napa. when I was rebuilding my engine I tried to go cheaper and got all new valve parts from napa. springs, valves, guides, keepers, and also some con rod bearings. The rod bearings were the only thing that fit. Guides were too long and too big on the od. springs were way too long. They bound before even getting close to max lift. keepers were wrong size. Stay with IH as much as possible. Mail order if you have to. We double and tripple checked all the numbeers and my engine to make sure the right stuff was ordered and it was correct. I have the c-123 with original firecrator pistons. Napa did have good ignition parts for mine but In my opinion IH parts are better and last longer.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|