|
Farmall & IHC Tractors Discussion Board |
Re: Generator to Alternator Mount
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 14, 2003 at 03:25:00 from (216.208.58.180):
In Reply to: Generator to Alternator Mount posted by DHuth2 on June 13, 2003 at 23:32:03:
I just weld a flat plate 1/4 thick 2" x about6-7" on top of old generator mount and weld tabs on top of that for alternator mount. I usually allow space enough for about 4 washers between tabs, makes fo easier alignment on belt. One problem, because of alternator shape you cant get close enough for belts to line up. I go to auto wreckers and get a double alternator pully off the older V8 cars. The ones I know will work well are Olds and Buick. By using the outer pully of the double this allows you to set alternator lower and back just enough for that. You can use the same belt as used on generator, but about 1" shorter tucks alternator nicer, makes it look good. Any questions just e mail me.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
