Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Hydraulic Gauge for 300 Utility--Where
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 10, 2003 at 10:21:15 from (64.228.12.175):
In Reply to: Re: Re: Hydraulic Gauge for 300 Utility--Where sho posted by Kilian on July 10, 2003 at 06:17:26:
Kilian: I understand what your driving at, I am more aquainted with the Farmall model. Short of cutting the high presure line from pump to system, I can't think of anywhere to tap in for what you are trying to achive. Having said that, a tractor doing what you are concerned about will put extra load on engine when there is no hydraulic demand. If you start tractor with no load on hitch other than hitch itself, move the hitch up and down. When hydraulic cylinder on hitch reaches the end of stroke you should notice substancial load on engine if hydraulic system is not properly by passing. 300's were famous for a bit of a surge just as demamd stopped, however it was only momentary. Same with power steering when demand stops you would notice load on engine. If you have a problem it should be easiest to detect at half throttle, or less. Just try that and try it with tractor cold as well as hot. I have put about 75,000 hours on IH tractors in my lifetime and have never seen this happen. I will not say never will never happen as these tractors are now a lot older than when I used them. One other question just hit me. Does your tractor by any chance have the draft controled hitch? That hitch was techicall new on 350 however over the years a few of them have made it onto 300's. If the draft control is out of time it can do this. Any system where by the further you push the lever the further the cylinder stroke goes, lever must be in time with cylinder. That is usually just a matter of adjusting linkage on lever so lever and cylinder reach limit together.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|