Farmall & IHC Tractors Discussion Board |
Farmall H oil leak
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by IH Man on July 19, 2003 at 10:56:03 from (209.240.198.63):
My mystery oil leak is coming out from above the "Lift-All" pump shaft access cover plate. I thought it was the transmisson shaft seal that drives the pump. As I reved up the engine and looked with a flashlight, the oil came running of of a hole between the two 13/16" bolts that bolt the transmission to the rear end on the driver's left side???? The hole is approx. 9/16 in dia. and I can stick a 1/2" bolt about 2 1/2" long in the hole. Is that a dowel hole for section alignment? theres nothing in it and the transmission oil runs out like sieve when RPM"s are up???? The right side location has threads extending out about one inch...between the two 13/16 section bolts...??? any feed back as to what goes in that right side hole would be appreciated....oil sur is leaking out it.....
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|