Farmall & IHC Tractors Discussion Board |
Re: Farmall 460
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve on July 28, 2003 at 16:04:59 from (209.240.198.63):
In Reply to: Farmall 460 posted by TC on July 27, 2003 at 18:22:57:
I had a Farmall 460 gas. I was never so happy to sell a tractor like i was when i sold it. It's an all around poor tractor. The clutch is to small. Only 10 1/2 inches, the same as a Super H. I had to replace the clutch many times. The engine has no low end power. I had to replace axle bearings on one side. A tractor axle is a poor place for ball bearings! The fast hitch is nice if you have or can find fast hitch implements. You better off buying a tractor with a real 3 point hitch. The TA is free wheeling in low (TA) If you have hills, the wife or kids driving tractor. The free wheeling is not good.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|