Farmall & IHC Tractors Discussion Board |
Re: M pto lever
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Delbert on August 03, 2003 at 06:32:47 from (63.77.102.145):
In Reply to: M pto lever posted by 49 Cubber! on August 03, 2003 at 04:34:18:
Years ago someone came up with the idea to make a lever that would mount on the right hand side of the platform under the seat. It was made out of half inch pipe maybe 6-8" long slight curve and then would have a rod running over to the pto lever that would engage the pto. Would have to have like a cable clamp to clamp rods together. This half inch pipe would have a bolt welded to it. The part that fastens to tractor would be flat piece of metal with pipe for bolt to go through put nut on bolt or drill hole in bolt to put cotter key in to hold it in place or both. Some of these were longer than 6 or 8 inches this should give you an idea of how to build a devise to help the guy next door out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|