Posted by Rootsy on March 30, 2009 at 12:06:00 from (24.176.37.149):
In Reply to: 560 implement size posted by RAW in IA on March 29, 2009 at 17:27:05:
my 560D (not turned up) doesn't even know my 10' IH #37 is back there... Even with the gangs full forward and back and the wheels off of the ground... 3rd gear, TA forward, Idle to WOT... doesn't matter...
Pulled a 14' in SE Michigan Lake Erie Clay most of it's life... and a 4-16" 412 semi-mount... Was turned up as far as she'd go with the stock pump in those days...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
