Farmall & IHC Tractors Discussion Board |
?? for Haas- Sickle bar mower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith F on August 11, 2003 at 07:53:11 from (67.37.213.65):
I am restoring the Super A sickle bar belly mower. You had responded before about having a manual for it. It is the A-22 type. I will describe my problem. I removed the belt pulley from the drive shaft and pulled the shaft out of the support tube. On the pitman flywheel end there is a support that bolts to the tractor. That support has been worn into by the drive shaft to the pitman flywheel. I need to see a picture of what the original setup was. There must be a bushing or something that has worn out to cause this. If you could help with a picture or a copy of a page from the manual it would be greatly appreciated. By the way I understand that you live in East Tennessee. I live in Maryville, just south of Knoxville.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|