Re: H Governor Ajustment

Posted by Wayne Swenson on August 14, 2003 at 10:33:07 from (66.228.233.51):

In Reply to: H Governor Ajustment posted by Nick on August 14, 2003 at 10:14:47:

This is your governor/carburetor synchronizing adjustment. With the vent cover open & engine OFF do the folowing:
1. Move the throttle lever to wide open.
2. Remove the cotterkey & pin from the clevis.
3. Rotate the carburetor rod to wide open.
4. The pin should slide in freely if the adjustment is correct. Loosen the lock nut and make necessary adjustments.
5. Reinsert the pin & cotterkey, tighten the locknut, close the vent cover, & go to work.
6.Check your spark timing.
7. Run the engine at maximum RPM & adjust the high speed mixture screw. Turn in until RPM's just begin to drop then turn out about 1 full turn for good mixture setting.
Have you considered that the "H" may just not have enough power??

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: H Governor Ajustment Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]