|
Farmall & IHC Tractors Discussion Board |
Re: Push / Pull On/off Switch for Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian on August 19, 2003 at 18:58:18 from (65.49.176.16):
In Reply to: Push / Pull On/off Switch for Super A posted by brian on August 18, 2003 at 18:46:54:
I do have the thick washer, the stop washer and the cap. When I tried to poke it through the hole between the light switch and the amp gauge, it just wouldn't fit through. I looked for the notch to make sure it wasn't hanging up on it too. I'm wondering if there is a difference with just the switches for the Super A's. I know I could just drill it out to make the hole bigger ... but I hate doing that. Hummmm Thanks
Brian.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
