Farmall & IHC Tractors Discussion Board |
Re: Carb. problems?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on August 21, 2003 at 11:50:36 from (66.84.205.26):
In Reply to: Carb. problems? posted by Ben in TX on August 21, 2003 at 10:34:40:
Ben, I had the same trouble with Dad's C which had sat for a couple years prior to his passing. When I began the task of trying to get it running I discovered I had rust, etc throughout the fuel system. Make sure you have good flow to inlet on carb. There is a screen in inlet elbow and check screen in sediment bowl. Until you have a good flow to carb it will not run correctly. Many have taken steel line off and temporarily placed a automotive type filter in line with carb to catch rust, etc until tank gets flushed out. I ended up having to remove tank and clean scale out and even then took a while to get everything flushed out. If in fact you do have good flow to carb, and the inlet screen is clean you likely have something in a small passage in carb....been there as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|