|
Farmall & IHC Tractors Discussion Board |
how much will it pull?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on August 22, 2003 at 09:41:09 from (162.39.57.33):
I'm looking at disking my new pasture this coming week. I'm hopefully going to be using my Farmall 504 gas good TA. I've got one set of wheel weights on the back tires, 70lbs weights on the front tires, and a full stack of suitcases on the front (about 750lbs). I've got another set of rear weights I could put on the back tires if needed.
I'm not exactly sure how big the disc is, haven't seen it yet. The guy I'm borrowing it off of uses a 4wd Belarus (about 48 hp). About how big can the ole girl pull? The ground is pretty flat and straight. Their is one hill about 20-30' raise over a 60' run.
Hoping the 504 will handle it. I've already had a JD in there plowing it, it would be nice to see an IH finish the job.
Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
