Re: hydraulics IH 574

Posted by RAS on August 26, 2003 at 12:24:03 from (148.71.18.81):

In Reply to: hydraulics IH 574 posted by Maple on August 26, 2003 at 11:29:22:

Your brakes are out. I know it still has brakes. The problem is all the lining wears off the disk plate and then the it is metal to metal. The new pistion is made so the oring will blow when the brake disk is worn. You will need to remove the fuel tank and fender assy, drain all the oil and remove the axles and you will find the brake disk, plate and pistions. When you go back together there are two oring on the pistion and one behind the carrier I would replace them all. Also before you install the pump back on the MCV you need to remove the regulating valve and flow divider valve and clean.. Watch the springs.. New oil, New brakes and changed filter after you run it about a hour. Hope this helps.

Follow Ups:

• Re: Re: hydraulics IH 574 Maple 20:38:20 08/26/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: hydraulics IH 574 Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]