|
Farmall & IHC Tractors Discussion Board |
Re: IH 350 Utility
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by parts man on September 06, 2003 at 17:17:47 from (142.166.122.99):
In Reply to: IH 350 Utility posted by Allen on September 06, 2003 at 17:04:46:
Hi Allen, I assume the bar your talking about is the one right on the shaft through the fan hub. It has a wedge bolt down through one side. It may be hidden in dirt and grease (ussually are). Clean of the bar and locate the nut on the side and drive out the bolt (CAREFULLY) and the bar should be able to be pulled off. This bar is what actually drives the water pump, the fan hub is on a spindle like a truck hind wheel, the bar drives the shaft through the center which the water pump impeller is on.
Running your hydraulic system without oil will damage the pump, possibly even cause the pump to seize. If the pump were to seize that would damage you timing gears, costly!
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
