Farmall & IHC Tractors Discussion Board |
Re: F-20 Oil Drain Petcocks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustywallace2 on September 08, 2003 at 12:09:19 from (205.188.209.140):
In Reply to: F-20 Oil Drain Petcocks posted by Dave in GA on September 08, 2003 at 06:21:06:
Hi this might work if it is leaking from where it screws into the oil pan. Take the petcock out and either get some plumers tape and tape it up real good (if you do this make sure you wrap it the opposite way to the left so it won't become unwraped when you screw it in) Or you can get some plumers 'dope' and put that on there real good and screw it in tight. If it isnt leaking from where it goes into the oil pan you can buy new ones from Stevens Ag Parts out of Lousiana for $4.95 each. You could probably call them and they would send ya a catalog there number is 1-800-333-9143. Hope it works!! Good luck rustywallace2
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|