Farmall & IHC Tractors Discussion Board |
Re: Farmall C Information
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian Schmidt on September 09, 2003 at 18:12:54 from (12.215.48.174):
In Reply to: Farmall C Information posted by Rodney on September 09, 2003 at 09:19:12:
Also, don't forget to lube the fan hub. Rotate the fan hub screw hole to the 3:00 position facing it towards the right of the tractor. Remove the screw and fill with 30w engine oil. Should top this off at least every year. Don't forget to lube the throwout bearing on the left side near the clutch housing. Remove the small round plug and look for the grease fitting straight in. Lube it with a couple pumps of chassis grease. Steering should be checked every so often too. Although, I have never done it. I think you have to remove the grill shell to do that. It is not that difficult, I have just never got around to it yet. Good luck!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|