Re: Belt pulley removal from crank - c123 engine,

Posted by RT (SE TX) on September 12, 2003 at 10:13:53 from (139.169.192.215):

In Reply to: Belt pulley removal from crank - c123 engine, HELP posted by RayP(MI) on September 11, 2003 at 17:57:09:

After stripping the threaded holes in the pulley using a balancer puller, I used a 3-jaw puller on the outside of the pulley. We tightened the puller as much we dared, then hit the side of the shaft of the pulley with a ball peen hammer. After every hammer blow, the puller would tighten up about a quarter turn. It came off using this method, and it doesn't look like the pulley is damaged. Can you still buy the wear sleeve for this pulley?

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Belt pulley removal from crank - c123 engine, Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]