Farmall & IHC Tractors Discussion Board |
Re: 400 Diesel - Take it or leave it?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jimmy King on September 28, 2003 at 08:33:06 from (63.189.9.2):
In Reply to: 400 Diesel - Take it or leave it? posted by Big Joe on September 27, 2003 at 15:17:12:
Had a 400D from 1971 to 1982 lot of raw power and smoke. Pulled a 7ft. roam offset plow and a 8ft. Tailerway plowing disc with two hedge corner post on it. Like the other post said always switch back to gas and run for a few mins to equalize temp. in head. This type eng. was used for a long time. My dad was born in 1914 he had told me about going with Granddad when they were trying out an IHC crawler pulling a grader on the 8 mile road disc when he was just a boy he said he sat on the hood and held onto the exaust pipe. Many times I have taken the muffler off the 400 with it running with just a pair of gloves on.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|