Farmall & IHC Tractors Discussion Board |
Re: Farmall Narrow Front End Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on October 04, 2003 at 19:28:28 from (66.248.97.54):
In Reply to: Farmall Narrow Front End Questions posted by Bill on October 04, 2003 at 17:47:56:
Hello Bill, I operated a Farmall Super C, H and M for many years farming in central Washington State. During the ground working time of the year we had the double front wheel trycycle set up. You had a lot better flotation in soft ground and would turn very sharp. When the planting and cultivating time came we went to the single front wheel. When planting we had a v ditcher in the center of our 6 row beet planter. The single front tire we used on our cultivating tractors was a sharp single rib tire and would follow the v ditch the planter made. When it was harvest time we did have one wide front that we put on our M when we mounted an IH one row beet digger. We also use the wide front when we had a Farmhand loader on the M. When plowing with 2 way plows you could get closer to the fence that with a wide front.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|