Farmall & IHC Tractors Discussion Board |
Re: 49 Farmall H.. No high gear?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by STEVEN H on October 08, 2003 at 16:23:36 from (209.103.199.86):
In Reply to: 49 Farmall H.. No high gear? posted by Bob S on October 07, 2003 at 19:17:45:
More times than not the gear is gone from improper shifting. most of the folks that run the farmalls try to shift on the go with out much luck. it is indeed possible, but you have to know what speed you are travleing and what the throtle level on the next gear would be in order to get teh gears to mesh. also if you have the belly pump ingaged that helps alot. 5th gear is a very common gear to have probelms with because most times whem pulling a load with an H the H does not have the power to make hills so fourth is used than on the go shifted back to 5th which will grind every time.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|