Farmall & IHC Tractors Discussion Board |
Re: h--carb.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Terry on October 31, 2003 at 17:52:42 from (67.250.216.139):
In Reply to: h--carb. posted by Pete Cormier on October 31, 2003 at 16:47:09:
Hi, Not an authority on this like some of the guys, but will try and help. If you don't have a schematic of the carb, it is easy to miss the cylinder shaped screen that is in the passage where the fuel line hooks up. This screen often clogs with debris and starves the engine for gas. You will need to pull the screen cylinder and clean it and the passage. I am thinking that you do this after you have soaked the carb. in cleaning solvent. If carb is really corroded and crudy, I have used a deluted solution of sulfuric acid, say 10 to 20% acid to water. Some will say this isn't necessary, my reply is, it worked for me! If I remember correctly, the bottom adjustment screw is for gas mixture, and the other is for air mixture. I believe there is another screw on the throttle linkage for idle speed. Make sure that your air passage is clear, I had a tractor that was full of mud wasps nests. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|